Metode Maximum Power Point Tracking (MPPT) dan Boost Converter Menggunakan Fuzzy Logic Controller (FLC) pada Modul Surya

Teuku Murisal Asyadi, Ira Devi Sara, Suriadi Suriadi

Abstract


Solar modules have current and voltage characteristics that are non-linear, so efforts must always be made to work at the maximum power point so that no energy is wasted. The characteristics of the solar module will change depending on the level of radiation and temperature which causes the output power of the solar module to fluctuate and become unstable. To reduce oscillations in the output power of the solar module, the Fuzzy Logic Control (FLC) method used using the boost converter. Several studies have been done to maximize the output power of solar panels, one of which is by using namely by using Maximum Power Point Tracking (MPPT). This study aims to obtain the maximum power point in a set of solar modules arranged in series and parallel through the performance of the FLC method. In tracking the maximum power point during normal operation, the fuzzy method works together with a boost converter. Fuzzy-based MPPT was tested on a solar module under several radiation and temperature conditions using Matlab / Simulink software. The Fuzzy design method shows better results compared to other methods. The results obtained show the advantages of the FLC method in terms settling time, power loss, and oscillation at the point of the operating system.

Keywords


solar module; maximum power point tracking (MPPT); boost converter; fuzzy logic control (FLC)

Full Text:

PDF

References


A. D. Hansen, P. Sørensen, and L. H. Hansen, Models for a StandAlone PV System, Riso National laboratory: Roskilde, 2000.

R. Boukenoui, H. Salhi, R. Bradai, and A. Mellit, “A new intelligent MPPT method for stand-alone photovoltaic systems operating under fast transient variations of shading patterns,” Solar Energy, vol. 124, no. 2016, pp. 124–142, Feb 2016.

S. Agarwal and M. Jamil, “A comparison of photovoltaic maximum power point techniques,” in Proc. Annual IEEE India Conference (INDICON), March 2016, pp. 1–6.

B. Amri and M. Ashari, “The Comparative Study of Buck_Boost,Cuk, Sepic and Zeta Converter for Power Point Tracking Phohotovoltaic Using P & O Method,” in Proc. 2nd Int. Conf. on Inf. Technol, Commun, and Electrical Engineering (ICITACEE), 2015, pp. 327–332.

J. S. Kumari, D. C. S. Babu, and A. K. Babu, “Design and analysis of P&O and IP&O MPPT techniques for photovoltaic system,” Int. J. Mod. Eng. Research, vol. 2, no. 4, pp. 2174–2180, August 2012.

Y. Y. Hong, P. M. P. Buay, and A. A. Beltran, “Maximum power point tracking of photovoltaic system using taguchi-based fuzzy logic control,” in Proc. IEEE Milan PowerTech, June 2019, pp. 1-6

U. S. Ali, “Z-source DC-DC converter with fuzzy logic MPPT control for photovoltaic applications,” Energy Procedia, vol. 90, no. 2016, pp. 163–170, Dec 2016.

A. N. R. Ahmed, K. Nowaz, J. Tasnim, and N. Afroze, “Efficient PV array modelling by analyzing PV system (cell/module/array) based on MATLAB,” in Proc. 2nd Int. Conf. Electr. Inf. Commun. Technol. (EICT), Jan 2016, pp. 492–497.

K.W. D. Kartini and Z. Noviardi, “Penerapan inferensi fuzzy untuk kendali suhu ruangan pada pendingin ruangan (AC),” in Proc. Seminar Nasional Informatika (semnas IF), May 2010, pp. 22–27.

P. Singhala, D. Shah and B.Patel, “Temperature control using fuzzy logic,” Int. J. Instrum. Control Syst., vol. 4, no. 1, pp. 1–10, Jan 2014.




DOI: https://doi.org/10.17529/jre.v17i1.17863

Article Metrics

Abstract view : 0 times
PDF - 0 times

Refbacks

  • There are currently no refbacks.


View My Stats

 

Creative Commons License

Jurnal Rekayasa Elektrika (JRE) is published under license of Creative Commons Attribution-ShareAlike 4.0 International License.